Cabletron Systems Access Server 316 Przewodnik Instalacji Strona 288
- Strona / 302
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Messages 900 – 999
26-10
Local -965- Dump failed
Explanation: The access server has not been successful in performing a dump. It will try
to perform a dump a number of times before generating this message.
Action: Refer to message 914 for more information.
Local -966- Transmission failure on NI
Explanation: The transmission of a packet has failed on the network interface (NI) due to
a physical layer problem.
Action: Press Ctrl/P on the console terminal to perform a self-test.
• If a fault is detected, messages 941 and 952 are generated. Refer to those messages for
additional information.
• If a fault is not detected, wait for message 953. If message 966 accompanies message
953, forward message 966, together with the sequence of events following self-test, to
your system manager. Otherwise, refer to message 953 for additional information.
Local -967- Parameter checksum error detected in NVRAM
Explanation: The self-test has detected a checksum error in nonvolatile random-access
memory (NVRAM).
Action: Reset the access server to its factory settings. If this fails to correct the problem,
refer to Chapter 29 for service information.
Local -969- Requesting type Software - software-id
Explanation: The access server is requesting software for a downline load. If type is
specified, the software requested is identified by software-id. If type is not specified, the
load host chooses the software, and software-id is not displayed.
Action: No user action is required.
Local -970- Specified load failed, retrying with default parameters
Explanation: The load device or image you specified was not found.
Action: No user action is required. The access server will fall back to the normal boot
sequence.
Local -991- LOAD channel set to ThinWire
Explanation: The software load channel was set to ThinWire.
Action: No action is required
- DECserver 1
- Network Access Software 3
- Problem Solving Guide 3
- Web site: www.dnpg.com 4
- Contents 5
- Chapter 4 SLIP/PPP Problems 6
- Chapter 14 IPX Problems 11
- Chapter 18 Messages 000 – 099 12
- Chapter 26 Messages 900 – 999 14
- Chapter 29 Service Guidelines 14
- Typographical Conventions 16
- Associated Documents 17
- Software WWENG2 MNENG2 WWENG2 20
- Image(s) MNENG3 20
- Verify the Load Host 21
- At an OpenVMS load host: 23
- $ MCR NCP 26
- Downline Load Request Failure 27
- Is Defined Correctly 28
- Messages 29
- $ RUN SYS$SYSTEM:LATCP 33
- Local> SHOW MEMORY STATUS 36
- Low Pool Size: 52480 bytes 36
- Low Pool Used: 1940 bytes 36
- Verify Service Rating 39
- Telnet Resource Problems 43
- Verify Internet Host Name 45
- Telnet Client Hung 50
- SLIP/PPP Problems 55
- SLIP Connection Problems 57
- Verify SLIP Host Address 58
- PPP Connection Problems 65
- Failure Reasons 69
- AppleTalk Access Problems 71
- 3. AppleTalk Gateway Route 72
- Verify AppleTalk Is Enabled 73
- Verify AppleTalk State Is Up 73
- Verify Cache Size Is Correct 74
- Verify Attached Host Software 75
- Local> SHOW PORT 1 ATCP 76
- Local> SHOW PORT 1 76
- Performance Problems 77
- AppleTalk Gateway Route 78
- SNMP Access Problems 79
- Verify SNMP Enabled 82
- Verify Network Configuration 84
- MIB Information 85
- (NMS), do the following: 87
- Reported 89
- Access Problems 91
- TN3270 Connection Problems 92
- Verify TN3270 Keyboard Maps 94
- Telnet Negotiations Problems 97
- Procedure 101
- Authentication Protocol 102
- Overview 109
- Introduction 110
- Verify Internet Address 110
- Local> SHOW SERVER STATUS 111
- Console Port Problems 112
- Problems 113
- Port and Device Problems 114
- Solution 115
- Verify the Port Configuration 127
- Test the Printer Port 128
- LAT Printing Problems 131
- Verify the Print Queue 133
- Verify LAT Group Codes 136
- Telnet Printing Problems 138
- Connection 143
- Listener 145
- Echoes or Double Lines 148
- Modem Configuration Problems 149
- Dial-In User Procedure 151
- Access Server 154
- Not Respond 158
- Does Not Respond 161
- IPX Problems 165
- Network Access Software 167
- Management Guide 167
- Server Port 168
- Accounting Problems 171
- Problems with Accounting Log 172
- Verify Server Console Port 175
- Remote Login Problems 177
- Rlogin Connection Problems 178
- Verify Rlogin Server Username 183
- More Information 185
- Rlogin Client Hung 186
- Suspend IO Sequence 187
- Properly 188
- Some Applications 189
- Directed TFTP Problems 191
- Incorrect Filename 194
- Action: None 197
- >>> b eth:mneng2 197
- Messages 000 – 099 199
- Messages 200 – 299 201
- Corrupted solicit request 209
- Messages 300 – 399 211
- Messages 400 – 499 227
- (Chapter 3) 232
- Messages 500 – 599 243
- Local> INITIALIZE 244
- Messages 600 – 699 249
- Messages 700 – 799 257
- (Chapter 2) 269
- Messages 800 – 899 271
- (Chapter 272
- Messages 900 – 999 279
- Messages 1000 – 1099 291
- Messages 1100 – 1208 293
- Service Guidelines 299
- What To Do 300
- Digital Networks 302
Powiązane produkty i podręczniki dla Networking Cabletron Systems Access Server 316
Networking Cabletron Systems CSX400 Dokumentacja
(74 strony)
(74 strony)
Networking Cabletron Systems CSX1200 Dokumentacja
(106 strony)
(106 strony)
© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.191 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji