Cabletron Systems 150 Instrukcja Użytkownika Pobierz pdf (Strona 15)

Small Office Remote Access Switch 15

IMPLE

EMOTE

RIDGING

ETWORK

Bridging and Routing Information

To configure the IP host interface:

1. Select IP Interfaces from the IP configuration menu.

2. Select to add an interface.

3. Enter the IP address assigned to this interface. For SITE1, this is 192.42.1.6; for SITE2, this is

192.42.1.7.

4. Enter the subnet mask.

5. Enter the MTU size.

6. Select the transmit broadcast address.

If IP RIP is enabled, enter the following additional information:

7. IP RIP receive control.

8. IP RIP respond control.

9. IP RIP v2 authentication control.

10. IP RIP v2 authentication key (required only if the IP RIP v2 authentication control has been

configured with a value other than “No Authentication.“

For more detailed information on the IP host operating mode, refer to the IP Operating Mode section

in the Configuring Basic IP Routing chapter of the User’s Guide.

ONFIGURING THE SECURITY

For this network configuration, we require no security. The default configuration is device security

enabled. To make the required configuration change, select Security from the Main Menu. Then

select Security Level. Finally, select No Security.

SAVE CONFIGURATION FILES

We have now configured all of the required information. Press 4 from the Main menu to save the

changes and then press <RET> to exit. Reboot the system to activate your changes.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 105 106

Brak uwag

Cabletron Systems 150 Instrukcja Użytkownika Strona 15