Cabletron Systems 150 Instrukcja Użytkownika Pobierz pdf (Strona 12)

EXAMPLE NETWORKS

12 CyberSWITCH

CONFIGURE THE CYBERSWITCH

Using CFGEDIT, we will guide you through the steps to configure the CyberSWITCH for a simple

remote bridge network. We will execute these steps in the same order as they appear in the

configuration menus.

Start the CFGEDIT configuration utility. Type the following command at the system prompt:

cfgedit

The following Main Menu will then be displayed:

ONFIGURING THE PHYSICAL RESOURCE INFORMATION

We start with configuring the Physical Resource information. Press 1 at the Main Menu to display

the Physical Resource Configuration Menu:

You may only configure the switch type. The rest of the resource information may only be

displayed.

We will next add the line information. Press 2 at the Physical Resources Menu and press 1 to add a

line. First, you will be prompted for the line name. You will then be asked to select which slot and

port you wish to use. We will use LINE1 as the line name, and slot 1, port 1 as the slot and port

combination:

You will then be prompted for the line interface type. For our example, we will be using point-to-

point lines. Press 1 as shown below to select this line type.

Main Menu:

1) Physical Resources

2) Options

3) Security

4) Save Changes

Select function from above or <RET> to exit:

Physical Resource Menu:

1) Resources

2) Data Lines

3) Access

4) ISDN Subaddress

Select function from above or <RET> for previous menu:

LINE NAME or press <RET> for previous menu: LINE1

Currently available Ports:

SLOT Resource Type Available Ports Switch Type

---- --------------- ----------------- ---------------

1 BASIC_RATE 1, 2, 3, 4 BRI_5ESS

Slot number from above? 1

Port number from Slot 1? 1

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 105 106

Brak uwag

Cabletron Systems 150 Instrukcja Użytkownika Strona 12