Cabletron Systems AirConnect 3Com Instrukcja Użytkownika Pobierz pdf (Strona 64)

64 CHAPTER 6: CONFIGURING THE AP USING THE ASCII INTERFACE

4 To enable or disable interfaces on the AP, modify the following parameters:

5 Verify that values reﬂect the network environment and change them as needed.

6 Do one of the following:

■ Select OK to register the settings.

Or:

■ Select Save to write changes to nonvolatile memory (NVM), which

generates a conﬁrmation prompt.

7 Select Save ALL APs [F2]

to save the RF Conﬁguration information to all APs with

the same WLAN Service Area.

This option saves the conﬁguration changes for the current AP, and sends two

WNMP messages to all other APs on the Known APs table to update their

conﬁgurations and reset them after the conﬁguration has been modiﬁed. You can

execute this option only among the same hardware platforms and same ﬁrmware

versions.

8 Select Cancel [ESC] to cancel any changes you made to this screen and return to

the previous menu

Radio Parameters The AP automatically conﬁgures most radio parameters. Exercise extreme caution

when adjusting radio parameters for the AP since these parameters affect system

operations. Options in the RF Conﬁguration window ﬁne-tune the radio and

WLAP functions. To conﬁgure the radio parameters, follow the procedure below.

1 Select Set RF Conﬁguration from the Main Menu to display the RF Conﬁguration

window.

2 Conﬁgure the settings as required. The table below describes the Conﬁguration

parameters.

Web Server Enables the use of a Web based browser to access the UI instead of

HyperTerminal or Telnet applications. An AP Reset is required for this

feature to take effect.

Access Control Specifies enabling or disabling the access control feature. If enabled, the

ACL (Access Control List) specifies the MAC addresses of wireless clients

that can associate with this AP. The default is Disabled.

Type Filtering Specifies filter type for packets received either Forward/Discard or

Disabled. The default value is Disabled.

WNMP Functions Specifies whether the AP can perform WNMP functions. The default

value is Enabled.

AP-AP State Xchg Specifies AP-to-AP communication exchanged. If Disabled prevents AP

Auto Configure and AP load leveling function. The default is Enabled.

Parameter Description

Ethernet Interface Enables or disables wired Ethernet. The default value is On.

PPP Interface Enables or disables serial PPP. The default value is Off.

RF Interface Enables or disables radio. The default value is On.

Default Interface Specifies the default interface (Ethernet or PPP) that the AP

forwards a frame to if the AP cannot find the address in its

forwarding database. The default interface is Ethernet.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 92 93

Komentarze do niniejszej Instrukcji

Brak uwag

Cabletron Systems AirConnect 3Com Instrukcja Użytkownika Strona 64

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Punkty dostępu do sieci WLAN Cabletron Systems AirConnect 3Com