Cabletron Systems SmartSTACK 10 ELS10-26 Dokumentacja Pobierz pdf (Strona 82)

6-2

Configuring Workgroups Using SNMP

6.2 WORKGROUP CONFIGURATION PROCEDURES

You should have a familiarity with networking concepts and principles. In

addition, a basic understanding of SNMP is helpful. SNMP Configuration

information is shown on the following pages.

To configure workgroups using SNMP, proceed as follows:

When writing to the els10-27WorkGroupType entry, the following checks are

made:

• If the els10-27WorkGroupNumber is less than 1 or greater then 8, the

command will be aborted.

• If the els10-27WorkGroupName field is blank, the command will be aborted.

• If the els10-27WorkGroupPorts is empty, the command will be aborted.

• If the els10-27WorkGroupType field is not 3 or 4, the command will be

aborted.

Step Action

1 Read els10-27WorkGroupCurrentCount. This will tell you if another

workgroup can be created.

If the value is less than 8, another workgroup can be created.

2 Read els10-27WorkGroupNextNumber. This is the next available

index into the workgroup table.

This number should be written to els10-27WorkGroupNumber.

3 Write the number returned from els10-27WorkGroupNextNumber

to els10-27WorkGroupNumber.

4 Write the new workgroup name to els10-27WorkGroupName.

5 Write the list of ports to be included in the workgroup, to els10-

27WorkGroupPorts.

6 Write a value of 3 to els10-27WorkGroupType.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 97 98

Brak uwag

Cabletron Systems SmartSTACK 10 ELS10-26 Dokumentacja Strona 82