Cabletron Systems EPIM F3 Podręcznik Użytkownika Pobierz pdf (Strona 34)

INSTALLATION

3-6

Figure 3-6 Shelf or Table-top Installation

3.4 CONNECTING THE MRXI TO THE POWER SOURCE

Note: The MRXI has a universal power supply. This allows you to connect

the MRXI to power sources from 85 Vac to 264 Vac, 47-63 Hz.

To connect the MRXI to the power source, plug the power cord into a

grounded wall outlet. Turn on the power switch at the back panel of the

MRXI. Verify that the PWR LED is lit, this indicates that the MRXI is

receiving power. After the MRXI runs a self test, the CPU LED flashes

green indicating normal operation. If the LED remains red, the processor

is faulty.

3.5 CONNECTING THE MRXI TO THE NETWORK

The procedure for connecting Ethernet segments to the MRXI varies

depending on the media and ports being connected. Refer to the following

list and perform the procedure described in the subsections that apply to

your MRXI:

• Network Port (MRXI-22/24), refer to subsection3.5.1

• EPIM-T, refer to subsection 3.5.2

• EPIM-X, refer to subsection 3.5.3

• EPIM-F1, F2, F3, refer to subsection 3.5.4

• EPIM-C, refer to subsection 3.5.5

• EPIM-A, refer to subsection3.5.6

A = 15 cm (6 in)

B = 46 cm (18 in)

C = 53 cm (21 in)

D = 213 cm (7 ft)

MRXI 10 BASE-T HUB with LANVIEW

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 81 82

Brak uwag

Cabletron Systems EPIM F3 Podręcznik Użytkownika Strona 34